DIAMANT Ultrametal UM1250 is a perfect addition for fast and effective repair on live and pressured pipes and difficult conditions. UM1250 is widely used in plants, ships and heavy industries where it is difficult to make sufficient surface preparation and emergency repairs are required. This specially formulated epoxy works on rust, weathering and even on wet and oily surfaces. Less Surface Preparation Required means faster work and shorter turnaaround times Excellent Adhesion and Strength Loads against rust and weathering Usable on Oily Surfaces due to special additives and formulation – less surface preparation is required Cures even On Wet Surfaces without additional hassle 1:1 Mixing Ratio by Volume makes for easy measurements Cures Quickly for Machining within 2 hours to do touch up or rework on pieces Final Hardness in about 3 hours Application Areas Shipbuilding, automotive, Oil and Gas and Metal-working industry, Used on housings, pumps, containers, engine blocks, cylinder heads, gearboxes, cooler, impellers, etc. Perfect Adhesion and load values and resistances against rust, weathering, even on wet or oily surfaces. Specifications Processing: Pot-life (+20°C) : 15 Minutes Pot-life (+30°C) : 10 Minutes Curing (+20°C) : 2 hours Curing (+30°C) : 1.5 hours Mixing Ratio 1:1 By Volume Adhesion strength 25 N/mm2 Cured state Full Cure (+20°C) : 4 hours Full Cure (+30°C) : 3 hours Shore D Hardness: 89 Tensile Shear Strength (DIN 53 283) : 22 N/mm2 Tensile strength (DIN 53 455) Bending strength (DIN 53 452) Compressive strength (DIN 53 454) Impact strength (DIN 53 453) E-Modulus shrinkage after cure (ASTM D 2566) almost 0% Temperature Resistance (short-term) -40/+150°C Temperature Resistance (short-term) -40/+100°C **Please request for updated Technical Sheet if you need. Values Reflected are for reference based off DIAMANT’s Technical Sheet compressive strength (DIN 53 454)
